Your Cart
Your Cart is currently empty.
Watch Our Tutorial
Follow our easy guide below to install your Aloma Glow Magnetic Wall Sconces & Candles.
INCLUDED IN STARTER PACK
(6) Magnetic Wall Sconces
(6) Magnetic LED Candles
(1) Stud Finder
(1) String Line
(1) Candle Charger
(1) Candle Remote
Consumer Note
1. Aloma Glow sconces are designed for use on walls made of DRYWALL ONLY.
2. The sconces use powerful magnets to stick to the metal screws and nails in the studs just below the surface of your walls.
3. The included stud finder is a helpful tool in locating the studs, which is where the sconces can be mounted.
4. Older walls made of lath & plaster or masonry, and all walls finished in tile or wood will not support the Aloma Glow Sconce.
STEP 1
Open your box and read the instructions. Scan QR code to watch tutorial, and organize your pieces.
STEP 2
Remove the charging cable from the box marked “remote and charging cable.” Make sure that all six candles are fully charged. When fully charged, the red light in the candle will turn off.
STEP 3
Place the stud finder on the wall just above eye level. Slowly slide it left to right, up and down in a large sweeping motion until it clicks and sticks to the wall. You’ve now located a stud!
STEP 4
Remove the string line from the box and insert it into the stud finder on the wall. The string line will serve as a guide to help you place the sconces on the wall.
STEP 5
Remove a sconce and position it under the stud finder. Slide it vertically under the string line until it clicks and sticks. Your first sconce is up!
Repeat this process until all sconces are on the wall.
STEP 6
Once the candles are fully charged, turn the candles on by sliding the ON/OFF switch on the bottom of the candle to the “ON” position. Carefully place the candles into the sconces. You will feel a magnetic click.
